P0145 BMW Fault Code
Check P0145 OBD Fault Code ReasonThe Camshaft Position sensor will signal the Engine Control Module when the #1 cylinder is ready for the spark plug to fire (top-dead-center on compression stroke).
The ECM uses the information from this sensor to help calculate fuel delivery and spark timing.
P0145 Code Symptoms :
The original multi-displacement system turned off opposite pairs of cylinders, allowing the engine to have three different configurations and displacements. P0145 code had an elaborate diagnostics procedure, including showing engine trouble codes on the air conditionning display. However, the system was troublesome, misunderstood by customers, and a rash of unpredictable failures led to the technology being quickly retired.
Diagnosis And Repairing P0145
P0145 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.
How to fix P0145 code ?
- Exhaust gas leaks
- Faulty front heated oxygen sensor
- Continuous oil flow to the VCT piston chamber
- Faulty Camshaft Position Sensor
At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source.
Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.
